The high-pressure cleaner manufacturer will take you to understand the principle of this product: the impact of water is greater than the adhesion of dirt to the surface of the object, and the high-pressure water will peel off the dirt and wash it away to reach a cleaning device that cleans the surface of the object. Because the high-pressure water jet is used to clean up the dirt, a little detergent is needed unless it is very stubborn oil stains, otherwise the foam produced by the strong water pressure is enough to take away the general dirt.
Structure and composition
1 trademark; 2 water inlet; 3 rear wheel; 4 cleaning agent nozzle; 5 high pressure water pipe; 6 power cord; 7 temperature control switch; 8 power switch; 9 high pressure water gun; 10 shield; 11 front wheel; 12 chassis; 13 Motor, high-pressure pump assembly; 14 heater; 15 fuel injector, ignition electrode assembly; 16 chimney; 17 car armrest; 18 fuel tank; 19 gunstock; 20 fuel filter; 21 fuel pump; 22 fan; 23 high-pressure ignition The coil is familiar with its structure and working principle.
Troubleshooting
During the use of the washing machine, it is inevitable that there will be malfunctions. When there is a problem, you should carefully find the cause according to the different symptoms.
1) The spray gun does not spray water
a) The water inlet and water filter are blocked. b) The nozzle is clogged. c) The heating coil is blocked, remove the scale if necessary.
2) Unstable water pressure
a) Insufficient water supply. b) The pipe is broken, the cleaning agent nozzle is not inserted into the cleaning agent, etc., causing air to be sucked into the pipe. c) The nozzle is worn out. d) The seal of the high-pressure water pump is leaking.
3) The burner does not ignite and burn
a) Insufficient air intake and white smoke. b) The fuel filter, fuel pump, and fuel nozzle are dirty and clogged. d) The solenoid valve is damaged. e) The position of the ignition electrode changes, and the spark is too weak. f) The high-voltage ignition coil is damaged. g) The pressure switch is damaged.
If the above problems occur in the high temperature and high pressure washer, the user can find the cause and troubleshoot by himself. However, if the washing machine has serious failures such as water leakage in the pump body or oil leakage in the crankcase, the washing machine should be sent to a professional maintenance department with complete accessories and strong technical force for repair, so as to avoid unnecessary economic losses.